NextPreviousHomeNew Container Layer Z axis is set by default to 500?

lightads | 3 years ago | 1 comment | 646 views

Is there any reason why the Z axis for new Container layer is set to 500?
After adding elements and then I rotate it's off center. So I always set X Y Z to 0 before I start but sometimes I forget.




Share this on FacebookShare this on X

Because the default camera position is set to (0,0,0). Placing the container at (0,0,500) makes it immediately visible.

I think your question is about a container inside another container. In this situation, the position could, indeed, better default to (0,0,0). Thank you for your request!

michiel, 3 years ago


Comment to this article

You must be logged in before you can comment to this article. Login | Register

More by lightads

About lightads

Using 3D BluffTitler to give me the edge in my video editing :)

127 articles 91,386 views

Contact lightads by using the comment form on this page or at filmingphotoguy@afrihost.co.za